Cutting cement board around shower valve?

If you have a shower head that has been installed directly into the wall, you may need to cut cement board around it to create a waterproof barrier. Use a circular saw with a drywall blade or a reciprocating saw to cut the cement board. Use a utility knife and sandpaper to smooth the edges. The inside of this cut should be flush with the wall.

Cutting cement board around shower valve in steps?

Here is a simple step-by-step guide on how to cut cement board around a shower valve: Start by marking two lines around the shower valve at the same level as the floor joists. Make sure the marks are perfectly even and perfectly aligned with the sides of the valve. Now, place a piece of tape over the marks and use a sharp tape measure to extend the lines up to the ceiling joists.

How to remove cement board around shower valve?

To remove the cement board around the shower head, use a screwdriver to loosen the fasteners that secure the board to the wall. If you have difficulty removing the board, you may need to apply heat and loosen the adhesive that holds it in place. Once the board is free, screw the shower head back into place.

Cutting cement board around shower valve hole?

To cut cement board around the hole for a shower valve, you’ll need to score the board, then cut out the hole. This is best done with a jigsaw or circular saw with a hole saw attachment. The hole should be slightly larger than the valve’s flange so the board can be smoothly installed over the flange. Before applying sealant around the board, you’ll need to roughen the surface with a sanding or sandblasting pad.

How to cut cement board around shower valve?

If you’re planning to do the tile installation yourself, you can cut the cement board around the shower valve using a jigsaw or a circular saw. The board should be cut flush with the shower pipe but leave the cement board covering the threaded portion of the shower valve. If you’re using a tile cutter, you can cut the board around the entire shower pipe. The cut-off piece of cement board will be used to fill the space between the shower pipe and the wall.