How big was the hole in the titanic in feet?

The hole that the iceberg created in the side of the Titanic’s hull was estimated to be about 20 feet in diameter. The hole was so large that it could have fit a small house inside of it. It is reported to have been about 12 feet deep.

How big was the diameter of the giant hole on the titanic?

The diameter of the hole on the titanic is estimated to be between 20-26 feet. This is an incredibly large hole for a vessel of this size, especially in modern maritime standards. The hole would have been much larger if the ship had lost its back end.

How deep was the hole in the titanic?

In contrast to the hole in the forward section of the ship, the hole in the stern was relatively small. It was about 20 feet long, 9 feet wide, and several feet deep. The hole was so small that it would have been possible to walk around it. The water in the hole was so deep that it would have taken a submarine to get to the bottom.

How big was the hole on the titanic?

The hole was about 20 feet in diameter. It was so large that the water pouring in could be seen from the decks on nearby ships. The hot, dense water that poured through the hole caused the wreck to sink faster. Steel plates and large pieces of the ship broke off and were sucked down as the hole expanded. In the end, the hole was about 20 feet in diameter. As the result, the titanic sank at a rate of about 17 miles per hour. Cooler water flowing down

How big was the giant hole in the titanic?

The hole in the Titanic’s hull was about 20 feet in diameter from the bottom, and 65 feet from the keel. It was located about 30 meters from the bow, where the stern had broken off. The area of the hole stretched over 30 meters from the front to the back of the ship.