How do I winterize my above ground pool pump?

Your pool pump must be drained before winterizing. Otherwise, you run the risk of water freezing in the pump’s internal components. We recommend draining your pool pump to the highest level possible. If you have a filter, you’ll likely want to leave it on so that the water won’t need to be drained. During the winter, you’ll want to place a foam pad over your pump to protect it from the elements.

How to winterize a pool pump and heater?

Your pool pump and heater are two of your biggest investments and keeping them working all season long is essential, especially in the winter when you’re not using them. The best way to winterize a pool pump and heater is to have them serviced before the first freeze. When your pool pump and heater are serviced, the technician will check the hoses and inspect the equipment for any signs of damage or wear and tear. They will add pool pump or heater cleaner and filter your water.

How to winterize above ground pool pump?

You will want to make sure the filter is clean. You can do this by draining the water and running a filter cycle. Once the filter is clean, turn the pump on and allow it to run for 24 hours. This will help to cut down on any algae and bacteria build up. When the pump is running, slowly pour a bucket of salt water down into your pool. Leave it there for about two hours. Now, turn off the pump and allow the water to drain. Once the water

How do I winterize a pool pump and heater?

Once the temperature drops below freezing, it’s time to winterize your pool pump and heater. There are a variety of ways to do this, and we’ll walk you through the process step-by-step. First, turn the pump off. You can do this either by switching off the breakers at the service panel or by using an electrical breaker box. If you don’t have access to electricity, you can use a manual switch to turn the pump off.

How to winterize a pool pump?

To winterize your pool pump, you will need to drain your pool. You will want to do this slowly, as a sudden rush of water could damage your pump. Once your pool is drained, you will want to check the power cable connections. If you are unsure if they are secure, connect your pump to the charger. If it runs, you have a secure connection. To prevent corrosion, you may want to add an anti-corrosion solution to your pool water.