How do you fix a toilet that doesn't flush completely?

If your toilet won't flush it could be due to several different reasons. The most common cause is that your tank is partially full or completely empty. To check this, first, remove the flapper (or the float-ball) attached to the tank. Then, insert a stick into the fill tube and lift the flapper so that it is about 1-2 inches above the water level. To check if the flapper is fully open, press down on it with your hand. If

How to fix a toilet that flushes but does not have enough water?

If your toilet flushes yet does not have enough water, it may be caused by a broken flapper. A flapper is a small metal or plastic flap inside the drain pipe that controls the flow of water into the toilet. If the flapper becomes loose or broken, it can cause a partial drain. Flappers are relatively inexpensive and can be easily replaced. If your flapper is broken, you can replace it yourself. However, if you are not handy, you should enlist the help of

How to fix a toilet that flushes but water is slow?

If the problem is that the toilet flushes, but the water is very slow or not at all, it could be because the seal on the flapper is broken or it is worn out. This is quite common, especially in older toilets. Flappers can be easily replaced and do not cost much. If the water is slowly trickling even when the flapper is properly placed, this is most likely due to a clog in the trap or the pipe. The clog can be caused by

How to fix a toilet that flushes half the time?

First, make sure the sink trap is clear. If the flapper is sticking up, it could be causing your flushing problem. If you have a cartridge toilet, make sure the cartridge is full. If it’s a tank toilet, you could be having a clog. Try flushing a few times and if it still doesn’t flush fully, it may be time to call a plumber.

How to fix a slow flushing toilet?

There are a number of reasons why a toilet might not be flushing properly. One possible cause is a clog in the toilet’s trap or the flush valve itself. Over time, hair, soap scum, and other gunk can build up in the trap or the flapper, causing a slow, incomplete flush. Try plunging your toilet several times to dislodge any debris that may be lodged in there. If that doesn’t work, you’ll need to