How do you open a garage door with a broken spring and cable?

If the garage door won’t open and you have already checked the manual and performed some basic maintenance, you are likely missing a single component of the garage door: the torsion spring. If the spring is broken, you will need to replace it. This is usually a pretty easy fix and can be accomplished by calling the garage door experts at your local home repair shop. Before you call a repairman, however, you should first try to open the garage door manually. If you can

How to open a garage door with a broken cable?

If you have a broken garage door spring and cable, here are a few options to help you open the garage door. If the cable is attached to the garage door opener often you can remove the cover plate and then take the cable out. If you can see the end of the cable, such as its ball, you can try to hit it with a stick to push it back into the garage door opener. If this doesn’t work, you can replace the cable. The new cable

How to open a garage door with broken cable remote?

The first thing you will need to do is locate your garage door opener and locate the broken cable. If it is not obvious, you may want to mark the location with a piece of tape. Once you locate the cable, use a pair of pliers to remove it from the garage door opener. Next, cut off the old part of the cable with a pair of shears. Be careful to only cut away the cable end and not the wiring inside. Afterward, replace the new cable onto

How to open a garage door with broken remote?

If you have a problem with your garage door opener and you have a broken spring or cable, you can replace it yourself very easily. All you need is a flat screwdriver, pliers, a screwdriver bit, and a tape measure. To remove the broken spring, you will need to disconnect each connection on the end of the spring. You will need to hold the spring in place and loosen the screw that connects it to the arm of the opener. Once the spring is free, you can

How to open a garage door with broken cable?

If the tension is gone, you need to check the cable connection at both ends. Sometimes the connection is loose. You can check this by keeping one end of the cable in your hand and turn the drum by moving the hand up and down, keeping the cable tight. If the cable is loose, you will feel a firm resistance. If not, the cable connection is fine. To free the tension from the cable, use pliers to pinch the cable at the connection point and slowly pull the cable