How to adjust hunter pro spray sprinkler heads?

First you will want to make sure the sprinkler head is turned on so you know there is water flow. Next, take the plastic cap off the sprinkler head and you will see two small screws. Tighten the screws until the head is snug. To make sure the sprinkler head is adjusted correctly, turn the sprinkler head until you hear a click. If it does not click, the sprinkler head is not adjusted properly. Test the sprinkler head by spraying water at an angle.

How to adjust hunter pro spray sprinkler heads at home?

You can do it on your own if you have the right tools. A screwdriver, pliers, a small flathead screwdriver and a plastic wrench are all you need. You need to determine which sprinkler head you need to adjust. Simply find the sprinkler head’s location and look it up on the sprinkler head’s packaging to find the size screwdriver you need. Once you find the right tool, you will need to loosen the screwdriver enough to insert the

How to adjust hunter pro spray heads on sprinkler?

Hunter pro sprinklers are made with a double-spring design. This allows the sprinkler to automatically adjust to uneven watering. Use the adjustment screw to tighten or loosen the spring. The spring tension determines how much the sprinkler head will move when a water flow is detected.

How to adjust hunter pro spray sprinkler heads on tractor?

After securely fastening the hunter pro sprinkler head onto the end of the hose, connect the hose to the sprinkler head via a quick connect. Next, flip the sprinkler head over and look for a screw at the top that will allow you to adjust the sprinkler head’s angle. Screw the screw in or out until a consistent stream of water is shooting out of the sprinkler head. If the sprinkler head is not allowing for an even stream, turn the sprinkler head

How to adjust hunter pro sprinkler heads without torque wrench?

If you don’t have a torque wrench, you can still adjust the sprinkler head’s fine adjustment screw without using a torque wrench. Just make sure to use your thumb to apply pressure on the screw while pulling the sprinkler head away from the wall. This will prevent the screw from turning deeper into the wall. Once the screw is set, tighten it down with a screwdriver or wrench. If you still see a leak, check the sealing nut. If it’s