How to backwash a pool pump?

For a clean and easy backwash turn on your pump and let it run for approximately 10-15 minutes. Set the float valve to the highest setting to allow the water to flow freely from the return and into the pump. Use the handle on your pump to move the switch to backwash. You may need to turn it off and on a few times to get the desired result. Once the pump has finished washing, turn it off. Remember to always turn the float valve to the lowest setting

How to backwash a saltwater pool pump?

Typically a saltwater pool pump is connected to a manifold and a filter. When your pool pump is on, water passes through the filter and into the manifold, and the filter forces the debris out of the system. The water that passes through the filter is then sent to your swimming pool through the pump. When your pool pump is off, the filter is bypassed and your pool is drained of any remaining water. In a saltwater pool, the filter is critical to removing salt and other minerals from

How to clean a pool pump?

The first thing to do is to drain your pool and then cut off the power supply to your pump. Set your pool pump to the slowest speed to ensure the water level does not drop. If you have a pump with a handle, turn it clockwise so the suction is pointing away from the filter. When the water level drops, turn the handle counterclockwise to let the water back into the pool. Now you can remove the filter. If you have a filter basket, you can

How to backwash a swim spa pump?

A basic backwash procedure should clean out any gunk that has collected in the pump’s tubing or motor, but the pump’s impeller will need to be cleaned as well. First, pull out the access panel and remove the impeller. You’ll need to use a screwdriver to remove it, and then use a towel to dry it off. Once dry, reassemble everything and fill the pump with water. Turn the motor on and slowly spin the impe

How to backwash a spa pump?

To backwash your hot tub spa pump, you need to plug it in and make sure your filter is in place. Once you have done this, slowly increase the water temperature to a comfortable level and add some salt water (this will help disinfect the system). Let your system heat up for a few minutes, then slowly start circulating the water. If the system doesn’t begin moving automatically, you might have a leak. If you suspect your spa pump is leaking, turn it off immediately.