How to backwash sand filter above ground pool?

There are two ways to backwash a sand filter for an outdoor above-ground pool One is to dump a bucket of water over the filter and let it drain back into the pool. The other is to use a hose and a sanitary hose-end (or a shop vac with a hose attachment) to direct water over the filter. These methods have pros and cons. Using a bucket to backwash a sand filter can be messy, and depending on the amount of water you use, you

How to backwash a sand filter in above ground pool?

First, make sure the filter is completely empty. If you have a pool vacuum, use it to remove any remaining water. Then, turn on the backwash pump. You should slowly pour water into the filter while keeping the backwash hose about three to five feet away from the filter. Once the filter is full, turn the water off and wait for the filter to drain. It may take several hours before the filter is completely clean.

How to backwash a sand filter in an above ground pool?

The best way to backwash a sand filter in an above ground pool is to do it using a system that allows you to add water to your filter. A sand filter that does not have a backwash system needs to be drained before performing this step. This can be done by using a strainer that is placed over the drain intake. If you don’t have a strainer, you can place a cover over your filter to prevent sand from escaping.

How to backwash water sand filter above ground pool?

We suggest you use a manual sand filter for backwashing your water sand filter above ground pool. The sand filter is a mechanical one so it is easy to do. All you need to do is to turn on the water pump, make sure the filter is not clogged and slowly push the sand into the filter from the top. When the filter is full, turn off the water pump. You will notice that the water flow is no longer smooth, it will be bubbling up. That is fine

How to backwash sand filter above ground pool water?

You will need to backwash your sand filter when the water level in the filter is lower than the sand level by about an inch or so. With a bucket of water, start by pouring a small amount into the filter. You may want to do this in a plastic tub so the filter does not overflow. Then, pour the water slowly and let the filter drain. You may want to use a strainer to catch the sand, so that you do not end up pouring water onto your pool deck