How to clean a carburetor on Briggs and Stratton lawn mower?

Since the carburetor is located right in the engine compartment, it can be incredibly messy. And in addition to that, the small size of the carburetor allows plenty of gunk to build up over time, making it much harder to clean. Fortunately, the job is not a complicated one. By following a few easy steps, you can have your carburetor looking much better than new.

How to clean a carburetor on Briggs and Stratton walk behind mower?

The carburetor on a briggs and Stratton walk behind mower consists of many small parts. To clean the carburetor on the walk behind mower, start by holding the choke knob in its off position. Spray a mixture of 50% water and 50% water and vinegar into the fuel tank. Let it sit for 10 minutes. Then, drain the fuel tank and the carburetor. Use a rag to clean the fuel intake pipe and the small holes in the carburetor�

How to clean a carburetor on a Briggs and Stratton mower?

The first thing you need to do is to replace the gas cap so it seals tightly. This is very important, as the pressurized fuel will leak otherwise. Then, with your engine running, you will need to remove your spark plug. You will need to do this slowly, as you could damage the spark plug if you try to take it out too forcefully. Once you have removed the spark plug, you will need to clean it thoroughly. Then, take a small amount of gasoline and coat the

How to clean a carburetor on Briggs and Stratton lawn mower starter?

To clean a carburetor on a Briggs and Stratton lawn mower, make sure that the spark plug is correctly seated. Unscrew the spark plug and clean it off thoroughly. Start the engine and let it run for a minute. Then, pull out the spark plug and let it cool down. Now, you can clean the carburetor with carburetor cleaner. If it is hard to get off, add a few drops of gasoline to the cleaner and swish the mixture around

How to clean a carburetor on Briggs and Stratton walk behind lawn mower?

You need to make sure the carburetor is off before you begin the cleaning process. Once you have the mower turned off, remove the fuel tank and place it somewhere safe. Disconnect the spark plug wires and move the choke to the off position. Spray the carburetor with carburetor cleaner. Let the cleaner sit for 30 seconds. Run the engine while spraying the carburetor again. Let the engine run for one minute and then shut it off. Use a vacuum hose to