How to clean your pool filter cartridge?

Firstly, turn the pump off and drain the water from the filter. Disconnect the cartridge from the filter housing and remove it. Use a wrench to loosen the nut that holds the filter cartridge in place. Use a bucket to hold a cup of hot water and some baking soda. Pour the baking soda into the cartridge and let it sit for a few minutes. Take out the cartridge and rinse it with warm water. Repeat the process if needed. Finally, put the cartridge back in place and tighten the

How to clean a pool filter cartridge?

After you have put the cartridge in your filter and attached it to your drain, you can start the filter to clean the cartridge. Leaving the filter running will allow the filter cartridge to do its job and pull in any debris it encounters. The filter cartridge is designed to capture particles that are small enough to pass through the filter, but large enough to clog the cartridge. Over time, this accumulation of debris will use up the filter cartridge’s ability to filter water. Once the filter cartridge is

How to clean your pool filter cartridge on a backwash?

If you have a bagless filter cartridge, there’s no need to do a backwash on it. Just let it sit for a few days. Or you can do a backwash on a filter cartridge on a vacuum. This helps remove any dirt and debris left on the filter cartridge and will also help to keep your filter cartridge working properly.

How to clean a pool filter cartridge on a backwash?

You can clean your cartridge filter by doing a backwash. A backwash consists of forcing the water that is trapped in the filter cartridge back through it. To do this, start by turning on your water pump to slowly fill the filter cartridge with water. Once the water level rises to the upper edge of the cartridge, press down gently on the strainer basket. Now slowly pull out the cartridge, keeping the pressure on the filter basket. After you pull out the cartridge, let it drain for a

How to clean a pool filter sand filter cartridge?

A simple way to clean a sand filter cartridge is to use a bucket of water with soapy water. Next, add a few drops of bleach and stir it. The cartridge will be able to absorb the disinfectant and the dirt. Soak the cartridge in this solution for approximately 30 minutes. After the cartridge is completely clean, turn the filter back on. The filter will be ready to use immediately.