How to cut a side fringe step by step?

A side fringe step is cut from two pieces of fabric that are joined together along their long edges. The two fabrics are then cut along the diagonals to form a diamond shape. The length of the step is adjusted by adding or subtracting fabric, and each step is finished with a ruffle. To add a little more flair, you can add a decorative border to the top of your step.

How to make a fringe step cutout DIY?

Before you cut out the sides of your step, make sure to accurately measure the width of the board that you have. If you cut the board too narrow, it will be difficult to fit the board onto the stairs. Also make sure to mark the board so that you can measure the length of the board correctly. This is important when it comes to fitting the length of the board onto the staircase Remember to cut the board in a way that it won’t damage the wood.

How to cut a side fringe tutorial?

For a clean cut, first, determine the length of your step and where you want to cut the fringe. Measure the length you need and add an extra few inches. If you want an accurate length, use a tape measure and a cushion to ensure the end of the tape is touching the board. Use a ruler to mark the board where you want to cut the board. Then, use your utility knife to make the cut.

How to cut a fringe step by step?

To add a little more detail to the edges of the side step, cut 1-1.5cm (0.5-0.7in) of the hair, then use a flatiron to create a slight wave in it. Then take some hair from the top and back of your front hairline, and bring it forward over your forehead to form a triangle. If you like, you can also add a small clump of hair at the front of your forehead to create a small point

How to make a fringe step cutout?

Remove the excess paper from the back of the board using the scrap paper method described above. For a clean cut, place the board against a wall, with the front edge of the board touching the wall. With the board held in place, mark the board’s position with a pencil on the wall where you would like to cut the board to create a perfect fit. Now, take the board and pull it away from the wall until you can see the mark on the wall. At this point