How to cut baseboard corners with jigsaw?

A jigsaw is the best tool to cut corners on baseboard trim. If you have a circular saw, you can use it as well, but this is much harder to do and will result in a less precise cut. A jigsaw allows you to cut corners to any shape. Even if you have a large board or a long baseboard, you can still cut corners. Cutting corners is not difficult, but it does take practice. Even an amateur can do it, but the results will not

How to cut corners on baseboard trim with jigsaw?

If you want to cut corners on baseboard trim, you need a jigsaw with a small blade. A jigsaw with a small blade is best for this project because it gives you complete control over the trim molding cut. A larger jigsaw blade will cause a jagged cut that will end up looking square. It will also be harder to cut the corners perfectly straight. A jigsaw with a small blade will allow you to make a perfectly square cut in the corners of the baseboard.

How to cut back corners on baseboard trim with a jigsaw?

To cut baseboard corners using a jigsaw, you’ll need a jigsaw with a small jigsaw blade, a clamp to hold the board, and a guide to position the jigsaw properly. Set the jigsaw blade to a depth about one-quarter of the thickness of the baseboard. Set a clamp to hold the board onto the jigsaw base and clamp the board down. Align the jigsaw’s guide with the corner of the baseboard and secure it in

How to cut back baseboard corners with a jigsaw?

If you don’t have a jigsaw, a power miter saw works great for this job. Put the baseboard back in place, clamp it down and then use the jigsaw to cut the corners back. The cut-off pieces can then be sanded and refinished.

How to cut back baseboard corners with a jigsaw

To cut the ends of baseboard molding, use a jigsaw. If you’re working with thinner molding and plan to cut the corners flush with the wall surface, you’ll need to use a jigsaw with a small saw blade. Set your jigsaw’s depth to the board’s thickness plus a fraction of an inch. You don’t want to cut your molding flush with the wall because it will look unfinished. For larger moldings