How to cut cement board around shower valve?

Cement board around shower valves is typically cut with a circular saw. You can use a jigsaw or a circular saw with a special attachment for cutting cement board. If you’re not used to working with circular saws, you may want to practice on some scrap pieces first. When you cut the cement board you’ll want to make sure not to expose the shower valve or the threads of the shower head.

How to cut cement board around shower fixture?

To cut cement board around a shower fixture, you will want to use a reciprocating saw or a circular saw. The best way to cut around a shower valve is to use a circular saw with a fine tooth attachment, keeping the teeth pointed away from the wall. This allows you to cut into the cement board slowly and prevent the board from splintering. After you have cut the cement board, you will want to use a utility knife to finish the edges and a sanding block to smooth the

How to cut cement board around a shower valve?

The first thing you need to do is be aware of the type of shower valve you have and how it is mounted. If it is a standard valve, you will need to cut it into a shape that matches the existing molding. If you have a a French drain shower valve, you will need to cut away the rectangular section around the drain to allow room for the compression fitting.

How to cut cement board around tub surround?

For the tub surround, you’ll need to cut a hole around the drain pipe to make room for the new drain pipe. You don’t need to cut the hole perfectly, since the plumber can do this when installing the new drain pipe. Just make sure the hole is big enough, so the new drain pipe can fit. You can also cut out a hole around the tub faucet, if necessary.

How to cut an inch gap around a shower valve?

If the gap is less than an inch, you’ll need to cut a shallow groove on the sides and back of the valve with a utility knife. If the gap is more than an inch, you’ll need to cut two grooves that run around the entire circumference of the valve. If the gap is still too narrow to allow a screwdriver to fit, you’ll need to either sand the gap a little more or add shims.