How to cut stair stringers?

To cut a straight line on a level surface, you’ll need a level board or a laser level. Measure the length of your new stringers and mark the location of the joint on the board. Set your board on the stringers, making sure it’s level. The line should bisect the stringers.

How to cut stair stringers without a miter saw?

A hand-held circular saw is often the best option for cutting down stair stringers if you don’t have a miter saw. There are a number of different ways to hold the saw. One way is to clamp the saw to a workbench so that it’s at an angle. You’ll want to have someone hold the stringers in place while you cut them.

How to cut stair stringers without a table saw?

The first option is to use a circular saw with a miter attachment. Set the miter angle to 45 degrees so that the edges are flush with the front of the stringer. Using a light touch, run the saw along the stringer’s edges to cut them to length. A circular saw can also be used to cut corners off the stringers, but it’s best to use a jigsaw for this.

How to cut stair stringers without a table saw and miter saw?

A circular saw is another good tool for making the “X” cut in stair stringers. If you don’t have a circular saw, you’ll need to rent one or borrow one from a friend or coworker. Set the saw on a plywood board that’s about a half-inch thick and secure it to a piece of plywood that’s the same length as the back of the stair stringer. Set the board down on top of

How to cut wood stair stringers?

Stair stringers are usually cut with a table saw or a circular saw. You can cut this odd-shaped piece with a very sharp blade and a guide. Be sure to wear safety gear, including eye protection, a respirator, and heavy-duty gloves to prevent injury. Test your blade by making a board sample first. If the board doesn’t cut properly, you’ll waste time and material.