How to disassemble a PS4 original?

Firstly, you need to remove the two screws on the side of the console located beside the eject button. The screws are attached to the system board. After removing the screws, detach the system board from the main body of the console. You can do this by grabbing the two tabs on the board and slightly pulling the board away from the main body. To further remove the board, you can loosen the four screws that hold it in place. Once the board is free, you can detach it from

How to open a PSoriginal casing?

To open the original packaging on the ps4 you need special tools. The main tool is called a jeweler’s saw, which is a very thin metal saw. It’s essential to use the saw very carefully as you can end up breaking it. After you have the right tools, you need to locate the plastic slots at the top of the case. This is very easy to do, as they are usually outlined with dotted lines. Once you have found the two slots,

How to disassemble an original PS

The easiest way to disassemble an original PlayStation is to use a small screwdriver and gentle force. It’s quite easy to do. All you need to do is take off the four screws at the top of the system and take off the plastic cover. Now you should be able to access the system’s motherboard. Disconnect the three small red and black wires coming from the board. This should be quite easy. After that, use your screwdriver and gently push the board

How to open a PSoriginal remote?

The best way to open a PS4 original remote is to remove the plastic cover, which will allow you to access the battery compartment and look for any corrosion or visible signs of wear. Once you’ve done that, you can carefully remove the screws that hold the battery in place, and then replace it with a new one.

How to open a PSoriginal?

This is not a very common question, but it does happen. If you are not sure if your console is original or not, you can always check whether there is a symbol of Sony somewhere on the packaging. If you are not sure, you can disassemble the console. The first thing you need to do is remove the power adapter. Once you remove the power adapter, you will be able to access the motherboard. This is where you need to locate the screws that secure the hard drive.