How to light a pilot light on a gas heater?
In order to ignite the gas that produces heat in this type of heater there is a small pilot light on the burner. This light is controlled by a simple switch on the heater. When you turn the switch on, the pilot light is lit. If you don’t have a working pilot light, your heater will stay warm but will not produce any additional heat.
How to install pilot light on a gas heater?
The gas connection of the gas heater to the gas supply line must be sealed tightly against the atmosphere. This is to prevent moisture from entering the gas heater through the connection. If you suspect that the gas connection on your gas heater is leaking, it should be replaced. Gas heaters with a gas leak should not be used. This can potentially lead to a fire hazard.
Light pilot on gas heater?
To light the pilot on a gas heater you will need to turn on the gas and then turn the thermostat to the temperature setting where you want the heater to start heating. Once the thermostat reaches the set temperature the gas will ignite. The pilot will turn on automatically. When the gas heater is on, the pilot light will turn off after about 30 seconds.
How to light pilot on gas fireplace?
The gas fireplace produces heat by burning wood, a fuel that is supplied through a pipe that runs down the wall. A gas fireplace igniter makes it easier to light the fireplace. The igniter is attached to the gas fireplace and has two prongs: one for the outdoor air intake and one for the flue. When you turn on the gas fireplace, the flue draws air. The air passes over the gas fireplace igniter and produces enough sparks to ignite the gas fireplace.If you do
How to light pilot on gas fireplace insert?
If you have a gas fireplace insert installed in your home, light the pilot using the ignition switch. If you have an older fireplace, you may need to use a match to light it or a fireplace lighter. If the fireplace insert is in a wall, you may be able to access the pilot from the outside. For more help with lighting a gas fireplace, see our other questions on this topic.