How to light a pilot light on a hot water tank?

The easiest way to light a gas hot water heater is to first turn the gas supply to the unit off (usually located near the water heater's gas valve; refer to your owner's manual for more detailed instructions). Then, locate the pilot light. Most hot water heaters have two or three gas flames, one located near the water heater's gas valve, one in the middle, and one at the bottom. The near-gas-valve flame is the "pilot" gas burner, which

How to light pilot light on hot water heater propane tank?

First, turn off the gas line and then locate the outdoor hot water heater. Make sure the tank is securely attached and aligned correctly. You need to be able to see the flicker of the pilot light from inside the house. Then, turn on the gas line and wait a few minutes. After about 15 minutes, the tank should be hot enough to turn on the faucet. If the water gurgles or sputters, then you have a gas leak Contact a professional immediately.

How to light a pilot light on a water tank?

Using the right kind of light bulb is important when trying to light a hot water tank pilot light. When a hot water tank is first installed, a pilot light may already be present. If not, you can purchase a hot water tank ballast from a hardware store that will automatically light a hot water tank’s pilot light when the water temperature reaches a certain level. However, if the tank does not have a pilot light, you’ll have to install one yourself.

How to light a pilot light on hot water heater?

You can use a match to light the pilot light on a hot water tank, but this is not a good idea. If you don’t have a match handy, use a glass jar lid or bowl lid and fill it with dry sand. After you are sure it is full of sand, put the lid on the tank and turn the gas valve on to heat up the sand. When the sand is hot enough, spark a match and light the gas burner.

How to light a pilot light on a water heater?

If you have a gas water heater and the pilot light is not lighting, there could be a gas leak. Turn off the gas supply at the gas meter and wait at least 15 minutes. After 15 minutes, turn on your hot water faucet and let it run for at least 10 seconds. If the burner does not light, there could be a gas leak. Contact a professional to locate the gas leak.