How to light a pilot light on a Williams wall heater?

You’ll find the heating element on the back of the wall heater behind the blower motor. You’ll need to turn the blower motor off first. With the back cover off, locate the heating element and remove it. Now you should have access to the heating element’s wiring. Connect the wires to the terminals and replace the heating element. Finally, reinstall the back cover and turn the blower motor on. The new heating element should be ready to heat your

How to light a pilot light in a Williams wall heater?

The first thing to do is locate the thermostat and look at the back of it. There is a small hole in the back, usually between the two screws that secure it to the wall. You will need to have a flashlight and a pair of pliers handy. If you don’t have pliers handy, use your regular pair of scissors to cut the wires that connect to the thermostat. Once you have the wires disconnected, you will need to remove the screw securing the

How to light a pilot light on a Williams wall heater?

The first step is to locate the thermostat. You’ll want to find it on the wall close to the wall heater. Once you locate it, you’ll need to press the “heat” button. This will cause the burner to light. Once the burner is lit, press and hold the “heat” button until the heater reaches the desired temperature. The burner will automatically shut off after the temperature reaches the set point.

How to light pilot light on Williams wall heater?

A pilot light is a small burner that is automatically ignited when the heating system is turned on. If you are unable to locate the pilot light, you will need to turn the gas valve to the off position until you locate the problem. If the thermostat is not working properly, your heater will not ignite. Check the thermostat’s wiring or replace it.

How do you light a pilot light on a Williams wall heater?

The pilot light on a Williams wall heater should be easy to find and light. Most models have a small red glass tube visible on the front. There should be a small metal rod inside the tube. The rod is the ignition point for the gas burner. Once the pilot is lit, the gas valve will turn on automatically.