How to light a pilot light on an oil furnace?

First, check the burners for spark, which usually involves crawling under the furnace and looking at the burner from underneath. If you see any spark, you’ll need to replace the burner. Next, turn the thermostat to its lowest setting (this is normally around 65-67 degrees), and wait 30 minutes. Once the furnace is cooled down and fully heated, turn the thermostat up to the temperature you want, but make sure the temperature remains constant. If not, you

How to light a pilot light on a furnace?

You may have noticed the small pilot light on your oil furnace The pilot light is the first stage of the furnace when it comes to heating your home. This small light will ignite your furnace if the thermostat is in the right position. If the thermostat is not set properly, the furnace will not start heating your home, or will not start at all. The reason being is because the furnace has not received a signal that it is time to heat your home. If

How to turn on a pilot light on an oil furnace?

At first glance, it seems pretty simple – you flip the switch and you have heat! However, there are a few things you need to be aware of before you do that. First, make sure the furnace is turned off. If it’s still running, you’ll end up wasting precious fuel and money – not to mention you could be putting your home at risk. Next, check that the gas is turned on. If it’s not, you won’t be

How to light a pilot light on an oil furnace with propane?

The first thing you’ll want to do is turn off your comfort system -- the furnace, humidifier and water heater. You’ll need to turn them off completely so your furnace isn’t running while you work on it. If you’re using a gas furnace, turn the gas off as well. If you’re using an oil furnace, turn the oil burner off as well. If you don’t know how to turn it off, consult your

How to light a pilot light on a furnace thankyou?

First, turn the gas valve to the on position. The gas valve is usually located at the furnace. You can also turn the thermostat to the heating setting and leave it there for about ten minutes to ensure the gas is circulating. You should only wait a few minutes. When you hear the gas make a hissing sound, it’s time to light the pilot.