How to make crossbow shoot fireworks bedrock?

tying the string is not as simple as it seems. We recommend using a small piece of tape for this. Next, insert the end of the string through a notch in the arrow nock and secure it with the tape. If you have no tape, use a small piece of plastic tubing or a piece of string. If your string is too thick, it will not fit through the nock. Now, place the arrow on top of the nock, where the string is, and pull

How to make fireworks launcher with crossbow bedrock edition?

You can make a launcher for fireworks with the help of a crossbow. You can use a kitchen knife to cut a thick branch. The length of the branch should be about two feet, and the diameter should be about 2 inches. You can also use a metal pipe to make the branch. The branch should be well-shaped so that it can support the weight of the payload. You can now place the branch somewhere in your yard. You can hang the branch on a strong tree branch so that

How to make a fireworks launcher with crossbow by bedrock?

Firstly, cut a block of wood of the length you need. The length of the block should be slightly more than the diameter of the wood. Next, cut two grooves about 10 cm deep along both sides of the block. Next, cut a groove at the bottom of the block to the width of your string.

How to make fireworks launchers with crossbow bedrock?

There are a few more ways to make a crossbow shoot fireworks. One of the ways is to use some PVC pipes. First, cut the PVC pipes to desired length, and insert a metal rod in each end. The metal rod should be longer than the length of the PVC pipes. Screw the metal rod tightly into the PVC pipes. You can use a small screwdriver or a wrench to secure the metal rod. Once this is done, add some sand and gravel to the PVC pipes. Add

How to make fireworks on crossbow bedrock?

Using a small bottle of baking soda, add a little bit of baking soda to the cartridge’s powder. Find two pieces of tape, one smaller than the diameter of the hole you created in the cartridge and the other slightly bigger. Put these pieces of tape over the hole to create a cap. Add the little bit of baking soda to the cartridge. When the cartridge is full, seal the hole with the tape. Leave the cartridge open for a few hours to allow the baking soda to absorb