How to measure storm door handle?

Door handle height is usually 2-3 inches from the floor. While the door handle thickness is usually 1-1.5 inches. Door hardware can vary greatly, so pay attention to the specific details of the door handle you’re looking for before ordering.

How to measure storm door latch?

Storm door lever measures 4-5 inches from the top of the door to the edge of the jamb. Storm door handle is located at the top of the door which is also the bottom of the door closer. Storm door latch is at the right of the door. Storm door lever is used to lock the door while storm door handle is used to open the door.

How to measure storm door pull?

The length of a storm door handle pull is usually about the same as the thickness of a dime, or about 6-7 inches. If your door handle is set at a different length than the standard, you may need to adjust how you open the door. Also, you may need to replace the door handle.

How to find door latch?

The door latch is the handle inside the door that locks the door shut. It is usually located near the door knob. There are two types of door latches: the bump lock and the side lock. Generally, bump lock is lighter and simpler while side lock is heavier and more complex. You can easily replace the bump lock door handle if it is broken. However, you should have a handyman fix the side lock door handle as it is more challenging.

How to measure storm door?

Measure the length of the door and the thickness of the door molding around the door. The thickness of the door molding is usually 1-1.5 inches. This is important because your door must have enough clearance to accommodate the thickness of the wood. If the door molding is too thick, your door will not fit properly.