How to mince garlic in thermionic?

First, place the garlic in a bowl. Remove the peel and chop off the top of the bulb. Add the garlic to the bowl. If the garlic is too hard, you can put it in the microwave for a few seconds to soften it. After the garlic is chopped, add water. Use enough water to cover the chopped garlic. Use a kitchen towel to cover the bowl and keep the water warm. Allow the garlic to sit in the water for about 20 minutes. The garlic will turn soft

How to make garlic clove seeds in thermionic oven?

garlic clove seeds are basically the edible part which is attached to the clove. To make garlic clove seeds, first of all crush the garlic clove using a garlic press. Grind the garlic clove into paste. Thereafter, heat up the garlic paste to about 150°C. The garlic paste when heated will start to bubble and the garlic clove seeds will separate from the paste. Using a flat and wide spoon, transfer the garlic clove paste to the strainer. This

How to mincing garlic in thermionic converter?

If you want to increase the speed of mincing garlic, you should use a thermionic converter. A converter is a metal tube with a small hole in the middle. The hole is usually covered with a piece of glass. The garlic is placed inside this tube and then heated by placing the tube over a burner or a heated oven. This enables you to mincing the garlic faster.

How to make garlic clove seeds in thermionic converter?

To make garlic clove seeds in the thermionic converter, first crush the garlic and add it to the converter. Now add water to the converter and mix them together for a minute. Then put the converter on the heating plate and allow it to heat for about half an hour. As the garlic boils, the clove will form a ball, which will float to the top. You will have to scrape the garlic off the sides of the converter. When the garlic clove forms a ball, take

How to make garlic seed in thermionic converter?

To make garlic seed in thermionic converter, you need to first cut off the top of a clove of garlic. Put the garlic clove on a flat surface, then put few drops of vinegar on it. Leave it for 20 minutes. You can put a garlic clove in the garlic seed maker to make the garlic seed. Ensure that you do not put the garlic clove with the cut off top in the garlic seed maker. When they are ready, you can pull them out of the