How to punch more holes in a belt?

Do you want to add more holes to your belt but don’t know how? Nowadays, a lot of people use a belt buckle tool to make a hole in the belt. This tool is so easy to use; all you need to do is insert it into the buckle and push it down. The belt buckle tool will automatically create a hole in the belt and secure it to the belt. This will allow you to add more holes in the belt.

How to punch more holes in belt loop?

The first thing you need to do if you want to punch more holes in your belt is to choose the right tool for the job. A plumber’s punch is the most common tool used for punching holes in a belt. Punching holes in a belt is very simple: all you need to do is align the plumber’s punch with the hole you want to make. Ensure that you mark the location of the hole on the belt before you start punching. Now, use the

How to punch more holes in a belt loop without making it look sloppy?

Review your belt’s measurements and cut two holes in the right places with a pair of scissors. If you don’t have a set of scissors handy, use a metal snip. You can even use a paper clip to snip off a belt section to make two holes. Now, take a strip of thread and tie the ends together to form a knot. Thread the hole through the belt and pull the knot tight so that the ends of the thread are tucked into the backside

How to punch more holes to a belt?

While you can get a hole punch accessory for an office machine, punching metal by hand is a great way to add personality to your belt. The downside is that it’s slower and requires more effort. Also, you need to make sure you have a spot on the belt that’s easy to reach. If you have a metal belt buckle, that’s a great spot. For a thinner belt, you can try a hole closer to the buckle.

How to punch more holes in belt loops?

A lot of men tend to wear their belts a little tight, and that can cause the holes to bunch up. If a belt is too tight, the loops will bunch together, and you won’t get any extra holes. If you want to add more holes to your belt loops, take a pair of scissors and snip a few away at the corners. This will even out the loops a little and make the belt fit better.