How to read a dial caliper video?

The dial calipers are another type of dial gage and are used to check the size of a hole. They are used for threaded holes too, where the internal diameter needs to be checked. A dial caliper is a simple tool with a dial as a reading. You can easily get a reading using the calipers and this video will show you how to do it.

How to read a dial caliper for a round?

First, dial in the end stop. The end stop is the point at which the dial indicator will stop and lock. Typically, the end stop is set by a screw on the unit. Most dial calipers have a simple hex nut that can be removed to set the end stop. If the end stop is not properly adjusted, the dial indicator will not return to zero when the end stop is reached.

How to read a dial caliper for a curve?

A dial caliper can measure the diameter of a curve as well, but you need a special curve dial on the device to do it. This tool is much more complicated to use than a straight-line dial, so you need to practice a little bit before you start using it on your own. The basic idea is to line up two points on the inside of the curve with the two points on the outside of the curve. To measure the diameter of a curve, push the two outside points together

How to read a dial caliper for a bowl?

A bowl dial caliper is used to take accurate measurements of the diameter of a bowl. By placing the bowl on a flat surface, holding the jaws of the dial caliper stationary and lining up the jaw dial with the bowl, a reading can be taken. When you’ve finished reading the diameter, you can return the dial caliper to its original position and read the bowl’s depth.

How to read a dial caliper for a star?

The star dial caliper measures the diameter of an internal star gage. Star gages are used on threaded holes to verify that the hole diameter is within the gage’s tolerance. When the hole diameter is slightly undersized, a stud will fit loosely. If the hole has been undersized to the proper tolerance, the stud will bind and be difficult to remove. If the hole diameter is oversized, it will be difficult to thread the stud into it.