How to remove a bathtub drain stopper?

If you have a bathtub drain that will not drain because of a clog there are several ways to solve this problem. One way is to use a plunger to push down on the clog, but this rarely works. Another option is to use a commercial drain auger which is a powered drain auger. If you have a clogged bathtub drain that is not caused by a large mass of hair, a drain auger will usually be able to remove it. However, if

How to remove a bathtub drain stopper in drywall?

If you have a bathtub drain that is stopped by drywall, then you can usually find the drain plug with a screwdriver or wrench. If you are unable to loosen the plug, then you will need to cut a hole in the drywall around the drain. This hole should be large enough to allow the drain to freely move. After the hole is cut, you can now remove the drain plug by hand. While you can try to pull the drain plug out, it may be a struggle

How to unclog bathtub drain stopper from behind?

If the bathtub drain is clogged from behind, you’ll need to follow the same steps as for the front. However, when doing so, you may need to turn the drain counterclockwise a few degrees. Doing so will allow you to see the drain better and will allow you to clean it better. You could also use the Plumber’s Snake to help break up any clog that may be forming.

How to unclog bathtub drain stopper?

First, turn the faucet off and leave it so that the water level is below the drain. If the drain is very clogged, you will need to use the plunger to dislodge the clog. But be careful, as the plunger can break the pipe. If the plunger broke the drain pipe, you will need to replace the drain pipe and the bathtub drain. In this case, you need to get a plumber to fix the problem. To dislodge a

How to remove a bathtub drain stopper without fingers?

The first thing you need to do is locate the drain stopper. This will be the small metal or plastic cup-like attachment that seals the drain. It should be attached to a flange above the drain, and should be attached using a compression fitting. If you can’t find the drain stopper, it could be hidden under a grime buildup. Remove any visible grime with a rag, and look underneath. Typically, the drain stopper will be attached with two or three