How to remove a pool drain cover?

First thing you should do is turn the pool drain off. Doing this helps prevent injury if a child or pet attempts to reach below the cover. The next step is to remove the cover. The best method is to use a pool cover lifter — it’s not as complicated as it sounds. Typically a lifter is attached to a long pole. This pole has a handle and a hook at the end. Once the cover is in place, position the hook underneath the cover on the closest

How to remove a pool cover drain plug?

If your pool has a drain cover, you’ll need to either remove or loosen the cover’s drain plug so that you can access the drain. A permanent drain plug will be attached to the bottom of your pool’s drain. A temporary drain plug is used for repositioning the drain during repairs. If you have a horizontal drain, you’ll remove it by removing the two screws that secure it in place. If you have a vertical drain, you’

How to remove a pool cover drain?

Typically, the cover is held in place by the lip of the drain flange. If the flange is damaged, the cover may slip off. When this happens, it’s best to remove the cover immediately so the water isn’t wasted. To do so, remove the cover slowly and carefully. You don’t want to pull the cover off completely and cause damage to it or the flange. Once you have removed the cover, check the flange to make sure

How to remove a pool drain cover pop up?

If you have a pop up drain cover on your in-ground or above ground pool, you can usually remove it by hand. Using a sturdy wrench or pliers, you can loosen the set screws that secure the cover to the pool deck. If you have an older pool, you may need to pull the cover up towards you as you loosen the screws. Once you have the screws loose, you can remove the drain cover from the pool deck.

How to remove a pool cover lid?

The most common reason for removing a pool cover is to do a drain cleaning. You will need to have your drain cover off to do this. If you have a vinyl pool cover you will want to remove the cover by pulling the ends of the cover away from each other. If you have a fiberglass pool cover you will want to push the corners in until they are up against the sides of the pool. This will allow you to grasp the corners and pull the cover off.