How to remove bathroom drain assembly?

You can remove the entire drain assembly, or you can do a partial drain removal, which will allow you to clean out the drain pipe. First, turn off the water line to the drain. You can do this by turning the stop-cock at the sink, or by using a faucet wrench. If you have a single-lever faucet, turn the handle to the “off” position. If you have a two-lever faucet, turn the

How to remove a bathroom drain assembly glue?

To remove the bathtub drain, you will need to apply some thick and sticky glue to the threads and nuts. If the bathtub drain is covered with any deposits, you will need to scrape them off with a small knife or screwdriver. After the bathtub drain is clean, apply some lubricant to the threads. Screw the nuts onto the drain, but don’t over-tighten the nuts as this could damage the threads. After the bathtub drain is fully attached, turn

How to remove a bathroom vanity drain assembly?

In this case you can use a hand auger to remove the drain. You can also use a tool called a T-shaped drain auger, which is made to reach the deeper threads of the drain. Sometimes, the problem is that the pipe is clogged and needs to be cleaned. To accomplish this, you need to use a pipe cleaner and a hand auger. If the drain has a U-shaped trap, you need to replace it. To do this, turn the trap clock

How to remove a bathroom drain assembly cast iron?

If your bathroom sink is clogged and won’t drain properly, it could be because of a bathroom drain assembly. A bathroom drain assembly is a metal part that is responsible for the connection between a sink drain and a P-trap. Sometimes the connection between the drain pipe and the P-trap gets corroded over time, which allows the water to back up. If the drain pipe is corroded, it will be harder to clean and will eventually need to be replaced. This type of

How to remove a bathroom drain assembly epoxy?

If the drainage pipe is joined to the drain pipe, you can use epoxy remover. Apply the chemical liberally to the drain pipe and wait for 30 minutes. Using pliers, pull out the drain pipe. You might need to use a rubber glove to avoid getting chemical on your hands. This process can be used to remove a bathroom sink, tub, and shower drain. If the drain pipe is in a wall, you will need to cut out the drain pipe and replace it.