How to remove bathtub drain assembly?

There are a few ways to do this. The easiest and most common method involves turning the faucet off and holding down the overflow drain. Apply a small amount of penetrating lubricant to the drain to help ease the removal. Ensure you don’t apply too much or you could end up dislodging the seal that keeps water in the tub Once the drain is lubricated, slowly pull the tub drain assembly out of the tub. You may need to use a pair of pliers

How to remove a bathtub drain?

First, locate the drain and the tub. With a plumber’s screwdriver or wrench, loosen the drain clamp. If the U-shaped clamp has corroded and hardened, it will need to be replaced. Once the clamp is loose, remove the drain and pull it out. If the drain is set into a drain pipe that is attached to the tub’s wall, you will need to pull it up and out. Never use a clamp to hold the drain in place as

How to remove bathroom tub drain?

There are several different types of tub drain assemblies. The type of drain fixture you have can affect how you clean the tub and how you can remove the drain. If the tub drain is a P-trap, you can remove it with a P-trap screwdriver. If you have a drain that connects to the overflow pipe, you will need to use a drain auger to remove the drain pipe. Other tub drains are ball-shaped with a flange at the bottom. To remove these,

How to remove a bathtub drain stopper?

Before removing the bathtub drain, loosen the tub drain assembly clamp. The usual bathtub drain clamp is usually located at the bottom of the tub drain. If the clamp is not loosened, it would be very difficult to remove the bathtub drain. If the clamp is tight, you would need to use a wrench to loosen the clamp. Afterward, you can remove the bathtub drain using pliers or a pair of screwdrivers. If you have difficulty removing the bathtub drain, then

How to replace bathtub drain assembly?

First, the drain pipe below the outlet should be removed. If there is no drain pipe below the outlet, or if the drain pipe is corroded, it should be replaced. Once the old drain pipe is removed, a new drain pipe should be placed in the hole. If the new drain pipe does not fit perfectly, it should be cut to the right length. Screw each of the drain pipe's four nuts on the threaded portion of the drain pipe fitting. Finally, add hot water to the