How to remove bathtub drain stopper?

You can remove the bathtub drain stopper either by using a hand auger or a plunger. First, turn the water off at the source. If you are using a hand auger, use a screwdriver to loosen the drain plug that holds the stopper in place. Then slowly insert the tool into the drain until you feel the resistance. You may need to have a helper hold the drain open while you turn the auger. Continue turning the auger until you feel the drain plug

How to remove a bathtub drain stopper without getting water on hands?

Bending the P-trap is often the next step in removing a stubborn bathtub drain stopper. You can make a short P-trap, which is easier to remove, by using a plumber’s jointing tool the same way you would install it. Or you can use a P-trap that is longer than the drain pipe. Try placing a towel or other soft item over the drain hole to catch the overflow. If the P-trap is too long, you may need

How to remove bathtub drain stopper without unsc

First, take a bathtub stopper removal tool along with a pair of pliers. These two accessories are necessary for this plumbing task as they will help to get the job done effectively. Unscrew your bathtub drain stopper slowly and stop when the tub drain is completely cleared of water. Plunge the drain stopper removal tool into the drain hole and tighten it slowly. If it still won’t loosen up, apply some plumber’s grease on the bathtub

How to remove bathtub drain stopper without getting wet?

Typically, bathtub drain stoppers are made of rubber or plastic, so they are easy to remove. Though sometimes they become stuck, you can still remove them using the right technique. To do this, turn off the water supply. Flush out the tub, and then loosen the drain plug as much as possible. Put a bucket under your drain to catch any water that might leak. Carefully pull the bathtub drain plug out about 1 to 2 inches. If the drain is very tightly cl

How to remove bathtub drain stopper without running water?

If your tub’s drain is clogged and you cannot turn off the water, you will need to do it without running water. The best way to do this is by first laying down a bathtub drain stopper removal tool on the drain. Next, you can use a wrench or plumber’s screwdriver to loosen the bathtub drain’s clamp that holds the tub’s drain cover to the drain pipe. After you remove the clamp, you can pull out