How to remove glued down vinyl flooring on concrete?

If you have glossy vinyl flooring on concrete, you need to be extra careful when removing it. You don’t want to damage the flooring or the concrete. If the flooring is very heavy, you can use a carpet lifter. You can also try a carpet lifter with a suction cup to lift the vinyl from the concrete. If you have a floor that is not very heavy, you can use a household vacuum to pick up the vinyl. If you use a carpet

How to remove glued down old vinyl flooring on concrete?

If you don’t know how to remove old vinyl flooring on concrete, then you need to look into methods that are not only effective but also non-destructive. Ideally, you would use a method that can make the old vinyl flooring easy to dislodge without causing any damage to the concrete or the vinyl itself. Apart from that, you should also be able to do the procedure without the need for any special tools or skill. If you are looking for a way to do this

Remove glued down vinyl flooring on concrete basement?

If you have a basement, you’re probably wondering if there is a way to remove the flooring and concrete floor that was installed with glue. The good news is that you can do it. If your floor has been down for a while, it will be covered in a thick layer of dust and debris. If your floor has been recently refinished, you might need to use a vacuum and some other tools to remove the dust and detritus. Once the floor is clean, you

How to remove old glued down vinyl flooring on concrete?

If the flooring is still in good condition, it can be salvaged. First, scrape up as much of the old glue with a putty knife and a bucket of soapy water. Be careful not to scrape the flooring or you will end up with small grooves. Let the floor dry, then sand it down. You can use sanding blocks or a circular sander. Finally, apply a thin coat of sealer to the floor and let it dry.

Remove glued down vinyl flooring on cement?

The easiest way to remove the tile flooring is to saturate it with water. Apply water to the flooring in a bucket or by using a hose, saturating the entire surface. Leave the floor wet for 30 minutes and take the time to scrape away any residual glue that may have dried up. Now, place a small amount of dish soap on a wet sponge and scrub the floor to dislodge the flooring. Let the floor dry for several hours, then carefully remove the flooring.