How to remove tile mortar from concrete floor?

Use a wet saw to cut the concrete around the tiles Apply lubricant to the saw and then cut the tiles off of the concrete floor. Once the tile is removed, remove any residual debris using a vacuum. If the concrete is porous, then sand the floor and seal it with an epoxy resin.

How to remove tile backer board from concrete floor?

When the tile wets the floor it can create a sticky residue — and when floor tiles are bonded to a concrete slab, they can pull away from the concrete. To remove the mortar from the concrete floor around the tiles, start by removing the tiles around the areas that have begun to bubble. Use a utility knife to scrape away at the concrete around the tiles, using a very gentle sawing motion to avoid dislodging the tiles. Once you’ve removed the sealant from the floor

How to remove tile backer board from concrete floors without damaging it?

If you have an unfinished concrete floor, the tile may have been attached using a cement backer board. If the tiles are not attached tightly enough, they may pop off the floor when you try to remove them. That’s especially true if the concrete floor has not been sealed properly. Fortunately, you can prevent this by first applying a sealer to the concrete slab. The sealer will help the tiles stay in place, and the tiles will be easier to remove without breaking. You can remove

How to remove tile backer board from concrete?

First, you need to look under the tiles to see if there is any visible residue of the cement. This could indicate that the tile floor is bonded to the concrete subfloor. If it is bonded, you will need to remove the tiles and backer board all the way down to the concrete. If it's not bonded, you will have to scrape the concrete off under the tiles until you see the flat, clean concrete. If the tile floor is stained or discolored, use sand and a

How to remove tile backer board from concrete floors?

If the concrete floor is tiled, you can remove the tile backer board using a utility knife. To do this, first score the tile floor with a utility knife where you want to remove the tile. Remove the tile backer board by gently pulling it away from the concrete, using a putty knife to help loosen it. If the concrete is slightly rough, wear protective gloves. If the concrete has lots of contaminants on it, use a floor cleaner first.