How to remove toilet paper holder no screws?

If you are not able to loosen the screw that is holding the toilet paper holder in place, you will need to remove the toilet paper holder by using a tool called a plumber’s wrench. This tool will allow you to either break off the screw or pull the holder away. You may also be able to use a screwdriver to loosen the screw, but this method can be extremely time consuming and may damage the toilet paper holder.

How to put toilet paper holder on drywall?

The first thing you will need to do is place the toilet paper holder on the wall and mark the screw holes on the back of the holder. Now, you need to drill the screw holes using a drill and screw the holder to the wall. Once you have securely screwed the holder to the wall, you will need to connect the two nuts to the screws. Tighten the nuts and you are done!

How to put toilet paper holder on wall?

The toilet paper holders are available in two varieties, wall-mounted and under-sink. They are also available with the traditional screw-based or wall-mounted devices or without the hardware altogether. The most modern bathroom wall-mounted devices are designed to reduce the need for tools and can be installed on any wall of the bathroom.

How to install toilet paper holder without screws?

Screw-free toilet paper holder is a very convenient product. Without screws, it is easy to quickly unclog it or clean it. And you don’t need to spend time on searching for the right screwdriver. Just loosen the screws above it and you can easily replace the toilet paper roll. And before you change the toilet paper roll, don’t forget to turn off the water supply in the sink, it is advisable to do so to avoid water tank overflow.

How to put toilet paper on wall?

The first thing you need to do is to find the wall studs behind the toilet paper holder. Once you have located them, you can mark them with a pen. Now, place a screwdriver over the screw that’s holding the holder in place, and push it in a bit to loosen it. You can then grab the holder and pull it away from the wall so that it is laying flat on the floor. Now, you can remove the screws, and use some masking tape