How to replace tub drain flange?

If the flange is corroded and has become loose, it will definitely cause a leak. If the flange is corroded, it will need to be replaced. If the flange is not corroded, but is loose, it can be tightened with a replacement clamp. Before replacing the flange, you need to remove the drain trap from the tub. With the trap out of the way, insert a wrench into the drain flange to loosen it. If you are unable to loosen the

Tub drain flange replacement?

To change a tub drain flange, you will need a special wrench that comes with the flange. The flange nut is usually underneath the tub. If you have a step drain, the nut holding the flange is in the tub. If your tub has no drain flange or has a screw-on drain cover, you will need to remove the drain plug. After you have removed the drain plug, you will need to loosen the tub drain flange nut using the special wrench. Once

How to replace tub drain flange yourself?

If you’re looking to replace your tub drain flange yourself, here are a few important things to keep in mind: First, you need to have a level floor and support the drain. A few tools you’ll need are a level, a tape measure, P-trap pliers, and a screwdriver to loosen the clamp. Make sure that the flange is completely flat against the p-trap, and that the flange is properly aligned. If the flange is

How to replace tub drain flange without removing tub?

To prevent the flange from being pulled off the drain pipe, put a clamp around the flange and the drain pipe where the flange connects. Slip a tube over the clamp and tighten the nuts on the opposite side of the clamp. You can then remove the flange from the drain pipe. To do this, press down on the flange with your hand and spin it counterclockwise. A slight pull should be able to dislodge it. Once it’s free, fit the

Replace tub drain flange cheap?

It is quite simple to replace tub drain flange. You need to take off all the old tub drain flange and replace it with new one. After that, you need to secure the new tub drain flange to the drain pipe with flange nuts or O-ring sealers. It is recommended that you use stand-off or compression set flange gaskets. You need to match the gasket material to the materials used in your tub, and cut the gasket to the right