How to reset maintenance light on Honda Civic 2007?

You can press the reset button repeatedly until the car’s maintenance light turns off. If you are unable to press the button, you can remove the drain plug from the front of the car and pour in some fresh oil. Normally, you should do this every 6 months, so you will need a new oil filter too. You should do this when the oil level is low in the car, say at least halfway. Doing this will help you avoid the problem altogether.

How to reset Honda maintenance light ?

If you are wondering how to reset the maintenance light on your Honda Civic 2007, then the very first thing you need to do is to locate the fuse. There are several fuses in your car, one of them is the fuse for the maintenance light. You can locate the fuse by opening the fuse box underneath your car and looking for the thick black wires. Once you locate the fuse, take a thin object and remove the fuse. After that, replace the fuse and turn on your car for the

Reset Honda maintenance light ?

the maintenance light on your Honda Civic is located in the engine compartment, usually near the battery. If the bulb is burned out (or busted), then it will cause the system to show a fault code. If the light is flickering oddly, that typically indicates that the bulb is loose. Try gently jiggling the bulb until it snaps back into position; if it still won’t stay on, then it’s time to replace it.

Reset maintenance light on Honda Civic ?

Let's say you're driving your car and suddenly the Honda Civic maintenance light comes on. Maybe it's flickering or stays on for a few seconds and then goes off automatically. Probably you have a sensor which is pointing out to the issue. There are numerous sensors in your Honda Civic that monitors the condition of the car. If one of them is not working correctly, it will trigger the maintenance light. The sensors are very important to car’s mechanics and technicians. They’re vital for

How to reset maintenance light Honda Civic ?

To clear the maintenance light error. Unplug the negative battery cable. If your car does not have a negative battery cable, unplug the battery for two minutes. Next, press and hold the brake and the clutch pedals at the same time, then press the ignition button. The engine will start. When the engine is running, press and hold the brake and clutch pedals again for two seconds. When the light is off, press and release the brake and clutch pedals.