How to reset oil change light Ford Escape 2008?

After you have replaced your oil, and the oil change light comes on, you have to reset it. There are two ways to do this. One is to turn the key to the ON position then press the oil change light reset button which is located on the top of the dip stick. The oil change light will then reset. If you do not have the dip stick or are unable to reach it to do this, then you can press and hold the oil change light reset button for 30 seconds.

How to reset oil change light Ford Escape?

If you are unable to reset the light, it is possible the sensor is bad. You can test this by removing the oil light bulb and attempting to reset it. If the light does not go off, the sensor may be bad. If the light is still on after you have replaced the bulb, you may need to replace the entire sensor.

How to reset oil change light dash Ford Escape ?

If you have already installed new oil and your Ford Escape oil change light is still on, you will have to reset it. To do so, press and hold the reset button located under the driver’s side of the hood. This will cause the oil change light to go off. Then, check to make sure the oil change light is completely off. If it still blinks, you will have to have this unit replaced.

Ford Escape reset oil change light?

The Ford Escape reset oil change light is located on the driver's side and is located in the small plastic cover under the hood. It is very easy to access, as shown in the photo. Just press down on the black plastic cover and it will pop up. You will see the oil change light inside the compartment. To reset the oil change light, simply press and turn the black plastic cover until it is tightly in place. That’s it! The light will reset and no longer flash.

How to reset oil change light on Ford Escape?

If the oil change light illuminates on the dashboard of your 2008 Ford Escape to indicate that your oil is due get an oil change. It is possible that your car has a bad sensor or a loose oil drain plug. You may be able to reset your oil change light by placing a paper clip over the sensor or the drain plug.