How to reset oil light on Jeep Wrangler 2012?

To clear the codes on your jeep you will need to clear the codes using the OBD-II scan tool. If the codes do not clear, it is possible that you have a sensor failing. If the codes still remain after performing a reset, it is most likely due to an intermittent oil pressure sensor. The intermittent oil pressure sensor is responsible for alerting the driver about the low oil pressure. If the codes are still remaining even after performing a reset, you will need to inspect the wiring

Reset oil light on Jeep Wrangler?

The most common cause of the warning light coming on is that the oil is low. Replace the oil if the oil level is beneath the dipstick. If the light is still on after you have replaced the oil, you should ensure that the oil level is even with the dipstick. If the oil does not get to the dipstick, it will be even lower than the oil level where the dipstick is. This is because oil has a tendency of getting down towards the lowest point in the oil

How to reset oil light Jeep Wrangler?

If you recently installed new engine oil, then you need to change the oil filter before the oil light will come on. You can usually find the new oil filter at your nearest auto parts store or in your Jeep Wrangler owners manual. You can also use new oil in the new filter if you want to. If the oil light won’t turn off after changing the filter, then your oil light is likely bad. It’s best to have your Jeep Wrangler oil light replaced at

How to reset check engine light on Jeep Wrangler?

Restart the engine, then press and hold the ignition button for 10 seconds. Disconnect the negative cable of the battery. Connect the negative cable back after 10 seconds. Now press the "Start" button. The check engine light should turn off. If the check engine light is still on after this procedure, then your Jeep Wrangler vehicle has a faulty engine sensor. If you want to do it yourself, you can do it by removing the negative cable of the battery and then connect it back after 10

How to reset oil light on a Jeep Wrangler?

If the blown oil light won't turn off, it's possible that your oil light bulb is burnt out. You can replace the bulb yourself, but make sure you have the right bulb. An easy way to check if the bulb is burnt out is to look at the wiring harness for the oil light. If the lights are blinking or on solid, you have a burned out bulb. If you have a new bulb, first turn off your Jeep and then start it again. Don’t crank