How to restore headlights with sandpaper?

Don’t underestimate the power of sandpaper! One of the best ways to get a glossy, spotless, brand-new look on your headlights is to use sandpaper. All you need to do is sand the headlight clean with a fine grade sandpaper, then apply a coat of wax, polish and you will have new headlights.

You can use sandpaper to remove scratches, stains, paint, oxidation and other contaminants that have accumulated over time.

How to restore headlights with sandpaper and paint?

You can sand the headlight housing to remove any rust or paint that has flaked off. Sanding the surface with increasingly fine sandpaper will create a roughened surface that acts as a barrier to moisture. Apply a high-gloss clear coat to the housing, again with sanding between coats. Your headlights should look like new!

How to restore headlights with steel wool?

Steel wool acts as a scrubby by removing carbon deposits from the bulb’s glass threads. The process can be completed in 20 minutes and does not harm the bulb’s longevity. After removing the carbon with the steel wool, you should rinse the bulb thoroughly with warm water. Don’t use any cleansers or soaps as they can break the bulb’s glass threads. If the wires inside the bulb have been damaged, you should replace it.

How to get headlights to shine with sandpaper?

If you’ve sanded down the headlight bulb and the bulb still won’t work, you’ll need to sand down the headlight housing. Rub sandpaper into the headlight housing where the bulb connects to the housing. Then, use a wet rag to clean off the sanding dust. Make sure to keep the sanding dust away from the bulb. Again, make sure the bulb is snug in the housing. If it’s not, sand the housing

How to restore headlights with sandpaper and epoxy?

A clean sanding and polishing is usually all you need to do to fix damaged headlights. Make sure you sand the entire surface of the bulb and the surrounding area. You can use sandpaper on a sanding block or by hand. The sanding should be done slowly and carefully to avoid scratching the surface. The light should be slightly glossy after sanding and polishing.