How to take apart a PS4 controller to paint?

Now that you have a working PS4 controller turn it over. The front panel has a few small screws that need to be removed, so remove them. Once the screws are removed, you will see the face plate. The face plate is held in place by two clips. To remove the face plate, gently pull it away from the rest of the unit. Now you can take apart the entire front panel to get access to all of the ports and buttons.

How to take apart PScontrollers to paint?

To access the interior of the PScontrollers, simply remove the two small screws that secure the battery compartment cover. After you’ve done that, take the two side covers off the button, D-pad, triggers, and L3 and R3 buttons. Now, it’s time to remove the gamepad s housing. To do that, first, take off the two wires that connect the L1 and R1 buttons to the motherboard. After you do that

How to disassemble a PScontroller for painting?

The best way to take apart a PlayStation 4 controller is to use a small screwdriver that is flat and thin. It should be about as long as the length of the four sides of the controller. Screwdrivers that are too long or too small will be difficult to use and may damage the controller’s components. After finding the right screwdriver, insert it into the slotted hole at the end of the controller’s top. Use this screwdriver to loosen the screws at the sides

How to disassemble a PScontroller for paint?

To dismantle a PlayStation 4 controller, you will need some tools, a screwdriver, and some patience. There are quite a few different parts that make up a controller and it can be confusing trying to figure out which pieces go where. The good news is that the PlayStation 4 controller is quite easy to take apart and most of the screws are very small. Still, it’s a good idea to have a few extra tools on hand just in case.

How to open up a PScontroller for paint?

To open up a PScontroller for paint, start by removing the plastic cover covering the face buttons. Unscrew the metal back portion of each button. Carefully pull the circuit board from the plastic housing. Set the board aside, exposing the contacts underneath. You’ll need to remove the silver wire, which acts as a ground, that connects to each button. Use tweezers to pull the wires out from the board.