How to test a refrigerator starter relay with a multimeter?

Using a multimeter to test a refrigerator starter can be challenging. That’s because the relay is protected by a protective cover and the connection wires are usually tightly wound, which makes it hard to visually check them. To make things easier, use a probe designed to connect the red and black wires to your multimeter. Connect the probe to each of the wires and press down on the probe’s contact point. If the wires are connected correctly, you will see a reading on the meter

How to test a fridge starter relay with a multimeter?

First, make sure the power supply has enough power. If it's not enough, your relay will not work properly. If you have a multi-meter, then you can test the power supply of the refrigerator. Connect the black probe of the multimeter to the black wire coming from the fridge power supply. Connect the red probe to the neutral line. Connect the black probe to the ground line. If the reading is correct (the meter should not fluctuate much), then your power supply is working

How to test a refrigerator starter relay with a volt meter?

If your refrigerator is making some strange sounds or simply not starting, it’s possible that the refrigerator’s compressor is failing. If you suspect this is the case, you need to test the compressor. One way to do this is to check the refrigerator’s compressor relay. In order to do this, turn the power off to the refrigerator and remove the cover over the compressor to gain access. Next, use a multimeter to measure the voltage across the contact points of the compressor

How to test a refrigerator starter relay with an ohm meter?

The best way to check the working condition of a refrigerator magnet start switch is to use an ohm meter. First, locate the start switch in the refrigerator and find the two terminals. This is the start switch where the magnet is attached. The start switch is usually located near the door. If you want to check the working condition of your refrigerator magnet start switch, connect one of the test probes of your ohm meter to the positive (or hot) terminal and the other to the negative (or

How to test a refrigerator starter relay with a DMM?

The easiest way to test a refrigerator starter relay is with a digital multimeter. If you have an older model, you might not have a continuity setting. In that case, you can use the “resistance” test setting to quickly determine if a short has occurred. If there is a short, you will get an infinite reading. If not, you will get the resistance of the solid state relay. For example, if your multimeter reports something like 0.5 ohms, then