How to thread a punch needle YouTube?

To thread a punch needle put the threaded end of the fine needle into the hole of the eye of the larger needle. Push the eye through the hole in the smaller needle. Now pull the thread through until it is tight. Remove the smaller needle and pull the thread through the hole in the eye of the larger needle. Now you have a threaded punch needle.

How to thread a punch needle at home?

To thread a small hole punch needle you need to pull back the thread to a certain length so that the knot can form to keep the end from slipping down. If the knot is too tight, it will be difficult to push the threaded end through the hole. First, cut a length of thread that is slightly longer than the hole in the punch needle. Slip the cut end of the thread through the small hole. If the hole is too small for the knot to form, use a small piece

How to thread a punch needle on jeans?

You can thread a punch needle on a sewing machine, but I highly recommend getting an iron-on threader. They are incredibly easy to use and thread a punch needle faster than a sewing machine. Just put the threader under your thread and push down gently until the hole is threaded. This is much faster and easier than trying to feed thread through a hole by hand.

How to thread a punch needle on jeans YouTube?

To thread a punch needle on jeans, you will need a piece of thread that is 25 to 30 meters long. The length of the thread depends on the size and thickness of the thread you are using. For denim, use medium-weight single ply thread. To measure the thread length, place some thread on a flat surface and mark the length you need. Afterward, thread the needle following the direction of the thread.

How to thread a punch needle step by step?

First of all, make sure your thread is even and thick enough. If it’s too thin or uneven it will be much more difficult to thread the needle. If your thread is too long, it will be difficult to hold onto when trying to thread the hole. Break off a small piece of your thread, then run it through the hole of the eyelet. Once you have an even length of thread, tie it into a knot. The knot should be just tight enough to stop the