How to truss a turkey Martha Stewart?

If you're new to cooking whole birds, it can be intimidating to figure out how to truss a turkey. Fortunately, it's an easy process that anyone can do, and the results are well worth the extra effort. To truss a turkey, you'll need a roasting rack and a large kitchen twine. First, set the turkey on the rack, breast-side up. Using kitchen twine, wrap the legs together. Tighten the twine and secure it with a knot

How to tie a turkey around a crown molding?

If you’ve never roasted a turkey in your oven before, you may not know about a part of the process called “ trussing ” This process involves tying the legs together and the neck to keep the bird from flopping over. To accomplish this, you’ll need to have some extra twine on hand. You’ll also want to have a few other tools at hand, including a sharp knife, some tape, and a ruler.

How to truss a turkey around a crown molding?

The easiest way to deal with the awkward shape of a turkey’s neck is to use molding when framing the turkey. You can either attach the molding directly to the wood framing or use molding strips to cover the outside edges of the wood framing. To create a nice finished look, use molding caps at the ends of the frame.

How to suspend a turkey on a crown molding?

When hanging a turkey on crown molding, you'll need to figure out a way to suspend it so that it’s level. One option is to use a board under the turkey’s legs that’s long enough to span from one level of the crown molding to the other. If the board is placed on the inside of the molding, you’ll want to use a board that’s at least 1/2″ thick.

How to truss a turkey to fit a crown molding Martha Stewart?

You can also add wood molding to the top of your turkey for added interest. For this method, first measure the length of your turkey and add about an inch to each side. Use a tape measure to mark where the legs end and the neck begins. Then, use a dremel with a small, circular saw attachment to cut a hole in the thick end of the drumbone. The hole should be deep enough to accommodate about two quarters of your molding. Insert the wood molding