How to use Drano max gel clog remover?

Put a small amount of Drano gel in a bucket of warm water (about 150 degrees). Soak the clog for a few hours, then pour off the water, and rinse the drain with a few more cups of water. This process will usually break up any clogs that were formed in the pipe. Try flushing your drains with a half cup of baking soda mixed with one tablespoon of water and some vinegar. Finally, pour boiling water down the drain again. Don’t be

How to use Drano gel clog remover?

First, cut off the cap of the bottle. Pour some of the gel in a small bowl and add water until it reaches a consistency of milk. Pour the gel into the sink or a bucket of water. Put the bucket or sink under the clogged drain Use the plunger to push the clog out into the bucket or sink. Let the water flow through the drain for a few minutes. If the drain does not clear, repeat this step.

How to get rid of clogs in toilet with Drano max gel clog remover

To remove the clogs in toilet you need to make sure that you have a good bathroom cleaning product that you can use. You will need to use a combination of chemicals and tools in order to thoroughly dislodge the clog. First, you will need to fill the toilet with water. This will help to dislodge the clog and break it down. Then you will need to add a few drops of Drano gel clog remover to the toilet water. You will need to run the

How to remove clogged Drano max gel?

Now that you have gathered all the ingredients, take the lid off the canister and pour about a cup of boiling water down the drain. The idea is to have enough water to fill the screen and the tub. Then, make sure to place the canister in the tub. Leave it for about 5 minutes so that the chemical can do its job. There are a lot of reviews online about this product, and many of them say that this method is pretty effective. If the clog is really

How to use Drano max gel clog remover to unclog toilets?

To use Drano gel clog remover to unclog toilets, start by pouring a small amount of the gel down the drain. Let the chemical solution sit for 30 seconds while the toilet is running. If the clog is still present, continue pouring the chemical down the drain for another 30 seconds. When the toilet is finished flushing, you can check under the rim to see if there is any residue left. If there is a residue left, then you know the chemical worked to remove