How to use Drano max gel in standing water?

The easiest way to clean up any standing water that has collected in your home or business is with Drano gel. If you don’t have any handy, it’s a good idea to keep a few cases of this product stocked. It makes quick work of removing any buildup in sinks, tubs, and floors, and can even eliminate odors and disinfect areas.

How to use Drano max gel to clean toilets?

A toilet with a clogged pipe can be a misery to clean. It’s not only an eyesore, but the standing water can cause mold and mildew to start growing in the bowl and on the floor under it. If you have a toilet that is clogged and has a strong odor, use a stick of white vinegar and a few drops of Drano gel as an overnight cleaning method. Next, pour some baking soda down the drain to help clean and neutralize the odor.

How to use Drano max gel on shower?

You can also use Drano gel on a shower head to eliminate buildup and prevent mold and mildew. Alternatively, you can pour the gel in your tub and let it sit for a few hours before draining it. Doing so will eliminate any bacteria or odor that could remain in the tub. Finally, if you have a bathtub drain that is clogged with soap scum, you can use the gel to clear the drain, which will eliminate the need to use chemical drain cleaners. Just make sure

How to use Drano max gel for shower head?

First, fill the shower head with hot water and let it run for a few minutes so that the mineral-rich water is suctioned out. Then, attach the plastic tube to the shower head. Put some of the gel on the tube and attach it to the shower head. Leave the shower on for a few minutes to saturate the gelled water throughout the shower and then turn it off.

How to use Drano max gel water heater?

You can use a bucket or a sink to pour the chemical into the water heater tank. Make sure to use a bucket, as the chemicals can be very toxic if they come in contact with your skin, eyes or pets. Always wear protective gloves, protective eyewear and long sleeves, as the chemical may be corrosive. Pour the solution into the tank until the water heater glugs. Leave it in the water heater for 24 hours, or until the water heater is fully disinfected and safe