How to use Drano max gel in toilet?

This is the final step where you will need to pour the remaining contents of the container into the bowl. If your porcelain bowl is very clean and shiny, make sure to use a clean rag. After the first few seconds, the contents of the bowl will turn milky and the clog should begin to break up. The faster your toilet drains the better!

How to use Drano 5 gel in toilet bowl?

Pour the contents of the tube onto the bowl, making sure the gel is spread over the entire surface. Leave it to set for about 10 minutes, and then scrub the bowl with a toilet brush. The bowl should shine, and the stains should disappear.

How to use Max gel in toilet?

First and foremost, you have to pour the Drano gel into the toilet bowl or tank. You can either pour it from the can directly into the bowl, or use the provided scoop or the pour-down tube. Once the gel is in the toilet bowl, you need to leave it on for about ten minutes. After the ten minutes are up, you can flush the toilet.

How to use Drano 5 in toilet bowl?

Add few drops of Drano 5 gel into the toilet bowl. Let the gel sit for about five minutes and then, scour the bowl with the toilet brush. Flush the toilet to remove the leftover gel. You can also use this method for plungers and other toilet bowl cleaners.

How to use Drano 5 gel in toilet?

To clean the toilet bowl, add a few drops of the gel and then turn on the water-flow. Afterward, let the water run for about 1 minute to scrub the bowl and dislodge the clogs. Finally, turn off the water. If you spot any stains, use the scrub brush to clean them. If the stains are stubborn, use the Drano Toilet Bowl Cleaner Spray to remove them.