How to use foil with circuit explore air 2?

Using foil with circuit explore air 2 is very easy, all you need to do is to position the suction cups on the surface of the water and tightly attach the hose to the device. Then turn on the fan and place the metallic plate where you want to get clean water. Now press the trigger button and the water will start to flow and collect on the metallic plate. Pour off the collected water and watch how the water gets crystal clear.

How to use foil with circuit explore air snap loop?

To create the snap-loop, lay a strip of aluminum foil over the dryer vent Fold the edges of the foil over the edges of the vent and secure it in place with tape. If you don’t have a dryer vent, you’ll need to cover the exhaust pipe with aluminum. Be sure to leave an opening for air to escape.

How to use foil with circuit explore air without loop?

The first thing you should do is create a small hole in the aluminum film and the plastic tubing. To do this, place the tubing over the foam, then slowly push the foil underneath the tubing. If you have the right tools, you can use a pair of pliers to grip the tubing and slowly pull the plastic down. This should create a hole large enough to insert your hand.

How to use foil with circuit explore air snap?

You can place the foil on the board’s surface and press it down firmly. Make sure the surface is flat. A few light taps on the board will be enough to get the circuit board to snap into place. The circuit board will have a snap-in position on the surface. Put the leds on the board and you are ready to go!

How to use foil with circuit explore air loop?

Use a single strip of aluminum foil to cover the length of your row of braid and the length of the coil. You can also use two strips to form a “U” shape on the coil. While the two-strip configuration works fine, it’s much easier to work with a single strip of foil. Once you’ve cut the strip to fit, tape it down over the coil and braid.