My TV won't turn on after power outage?

There are a few reasons why your television will not turn on after an outage and the most likely reason is a blown power supply. When the power goes out, it is incredibly important to check the power supply to your TV. If there is any corrosion or damage to the wires connected to the TV’s power supply, they will not be able to transfer power to your TV. Fortunately, there are very easy ways to check the power supply to your TV.

My TV won't turn on after power went out?

If you have a new tv the likely cause is a software issue. Your TV will need to be able to communicate with your home’s power source before it can power on. If your TV is older (anything over five years old), you will have to replace the motherboard. If not, you will need to have your TV serviced.

My TV won't turn back on after power outage?

If you are having issues with your TV turning back on after a power outage, there are a few possible causes for this and it is important to know which one is to blame. First, consider whether you are using an energy efficient TV that uses a small amount of electricity. If so, you may need to invest in a new TV. Also, if your TV is connected to a DVR or similar device, you may need to unplug it and restart the TV.

TV won't turn on after power outage?

One of the most common reasons your TV won’t turn on after a power outage is that a surge suppressor (see below) is connected to the TV. If you don’t have a surge suppressor, you can purchase one from a hardware store or online. Make sure the surge suppressor is properly connected to the TV.

My TV won't turn on after a power outage my TV remote?

If your TV won't turn on after a power outage and your remote is acting funny, it's likely because of a lost or broken button. If you've tried to press all of your remotes' buttons and nothing has worked, then your TV is probably not going to magically turn on. This issue is most commonly caused by a lost or broken IR blaster, which is the part of your TV that allows your remote to send out signals. If this is the case, then you'll need to