Toilet won't stop flushing no tank?

toilets are complicated machines. One of the most common issues homeowners are faced with is a toilet that won't stop flushing. Often times, this issue can be resolved by simply replacing the flapper or the flapper seal. Flappers are rubber seals that are attached to the flapper arm. When the toilet is flushed, the flapper arm swings down and hits the fill tube, preventing the water from overflowing. If the flapper is damaged, it won't seal properly, allowing water

My toilet won't stop flushing water?

If your toilet won’t stop flushing water, it’s most likely because you don’t have a tank. If you remove the tank and look inside, you’ll notice a float that moves up and down with the water level of your toilet. When the water level gets below the float, the float tells the tank to stop sending water to the bowl for a few seconds. If you don’t have a tank, the flushing action will repeat until

My toilet won't stop flushing water tank?

This is a common problem that usually happens because of a poor toilet seal. As the toilet seal degrades, the toilet bowl will start to leak. To check if your toilet has a leak, place some baking soda in the bowl. If the bowl gurgles, the toilet has a leak. If not, your toilet will still continue flushing. Check your flapper and make sure it is securely seated. If it is, you will need to replace the toilet flange. If the fl

Toilet wont stop flushing on gas?

It is very common in homes and commercial buildings to have toilets connected to gas water heaters. If you have a gas water heater connected to your toilet, then it is possible that the flushes are being triggered by the water heater. This could be caused by a broken ballcock or a clogged flapper. To check if this is correct, you should first turn the gas to the off position and wait for 15 minutes. If you still hear the flushes, you should call a plumber

My toilet won't stop flushing?

If your toilet won’t stop flushing, it’s most likely because of a clogged pipe. When a toilet clogs, a large amount of water gushes down the drain every time you flush. This can be extremely annoying and wasteful (not to mention messy!). The first thing you should do is check to see if there’s water running under the sink. There should not be any water. If you find water, turn off your water supply at the stopcock